OPF-P365 SIG-LOC, RMRcc is an RMRcc adapter plate for SIG P365 series pistols with the SIG-LOC (
not SIG-LOC Pro that is longer and uses the DPP footprint).
SIG continues to have rolling changes on its pistols. SIG-LOC is the 3rd footprint for P365, instead of the threaded M3 posts, SIG-LOC uses M4 screw holes.
NOTE:
To minimize RMRcc's installed height of, the design does away with full length sight support that would have added 0.05" to the plate, RMRcc's sealing plate (comes with RMRcc) is required. RMRcc ships with a sealing plate, it can be found below the foam in the RMRcc case.
OPF-P365 SIG-LOC, RMRcc is compatible with P365 family of pistols that use the 2025 and onward SIG-LOC footprint. If you're uncertain which version of optics pocket you have, please remove the cover plate and the changes are subtle but noticeable as the picture below shows, or call us at 214-399-7579 and we can confirm it for you.
Backup sights are available for OPF-SIG-LOC, RMRcc: BIS P365X
The front sight height (measured from the top of the slide, not from the front sight dovetail) is 0.51" to be usable. RMRcc itself is often deemed dependable and robust enough to not need backup sights. If you're using OPF-P365 SIG-LOC, RMRcc with an RMRcc for duty, be sure to check with your agency's rangemaster or armorer regarding backup sights, each agency can have different requirements regarding backup sights for low vis and off duty weapons.
Plate-to-slide: T20 M4 0.7 x 8mm. Torque value: 20 to 25 in lb.
Sight-to-plate: T10 5-40 x 3/8. Torque value: 18 to 20 in lb.
RMRcc has a unique footprint, RMRcc plates are incompatible with sights with an RMR footprint and Holosun 507k or EPS footprint.
Machined in 17-4 stainless steel, black nitrided.
Made in USA.
For Vibra-Tite VC-3 instructions and data sheet, please scan the QR code below.
